perksbas.blogg.se - Samson sound deck software download

Click on Track 1's maximize button (indicated by the arrow below) to expand the track and see its parameters.

Create a new project by going to File | New and select "Normal" from the list of templates.

If you are prompted with the message “Changes will not take effect until next time you start the program…” close SONAR LE by going to File | Exit. * Note: Throughout these instructions if you do not see an button in your software, click instead. SONAR LE is now configured to use your Samson microphone for recording. If prompted to restart SONAR LE, do so now.

In Options | Audio on the General Tab set your Record Timing Master to your Samson microphone.Ī) If your Samson mic contains a headphone output jack, then assign your Playback Timing Master to it as well.ī) If your Samson mic does not contain a headphone output jack, then select your internal sound card or audio interface for Playback Timing Master.

Note: Depending on your model microphone it may be listed by its model number or simply as "USB Audio CODEC" or “USB Audio Device”.Ī) If your Samson mic contains a headphone output jack, then highlight it for Output Drivers.ī) If your Samson mic does not contain a headphone output jack, then select your internal sound card or audio interface for Output Drivers.

In Options | Audio on the Drivers Tab, highlight your Samson microphone for Input Drivers and click *.

Would you like your hardware to be tested now", click.

When prompted with the message "We must now perform a series of tests.

On the Advanced Tab, set your Driver Mode to “MME (32-bit)” and click *.

Launch SONAR LE and go to Options | Audio.

To configure SONAR LE for use with your Samson USB microphone

Configuring SONAR LE for use with Samson USB microphones Last updated on